Welcome to Pepagora.com, Join FreeSign In
Industrial Coatings
Industrial Paints
Industrial Primers
Its Free
We offer Epoxy coatings, which is our Epoxy Polyamide Cured Hi-Build Epoxy Finish.
We offer Epoxy coatings, which is our Epoxy Polyamide Cured Hi-Build Epoxy Finish. Our coatings is a two pack polyamide cured High Build epoxy coating, which specially prepared for use in painting storage tank exteriors exposed to humid, saline and chemical environment. The coating helps to resist crude and refined petroleum oils and it gives protection against chemical fumes and spillage of alkalies, salt, solvents or mild acid solutions. These coating are widely used in heavy duty systems for power plants, refineries & petrochemical units, gas plants, fertilizer plants, chemical plants, pulp & paper mills. The preparation for various surfaces is given below: STEEL SURFACES:For this, surface should be completely clean and dry before applying primer. degrease and blast clean to Sa 2½ grade minimum of Swedish specification SIS - 05 - 5900 - 1967.If blast cleaning is not practical for the user, make full use of mechanical tools along with manual cleaning and wire brushing to eliminate loose rust/scale to St 2 or St 3 grade of Swedish specification.CONCRETE SURFACES:For new concrete surface, should be ensured that the surface is cured for minimum 2 months. Remove laitence, loose surface powder by light sand blasting. If blast cleaning is not feasible, roughen the surface by acid etching with 10% Hydrochloric Acid solution followed by thorough freshwater hosing to remove any residual acid. The surface should be perfectly dry and clean before applying primer.For old concrete surface: Remove grease and oil by solvent wiping. Remove water-soluble contaminants by fresh water hosing. Roughen the surface by acid etching, if light sand blasting is not feasible. The surface should be absolutely dry and clean before applying primer.
Air less spray / Brush Airless spray essential for the required high film build and uniform finish Tip Range 21 - 26 thou. Notes on Airless Spray: Total output fluid pressure - 2500 - 3000 psi. (176 - 211 kg/sq.cm.) Pot life : 2 - 4 hours Thinner : SPL No.1 only looking navi-mumbai&mumbai area.
