Soda And Soft Drink Making Machines

Additional Details

Stainless steel carbonators The carbonator is basically a stainless steel pipe of dimensions 8” diameter and 3. 5 feet height. It is fed water by a stainless steel triplex pump and Co2 through a pressure regulating valve. The whole assembly is mounted on a cast iron stand & base. The description of each part is as follows: The carbonator pipe is made of ss 304 grade. Water is fed from the pump into the top of the carbonator through a SS pipe set and a non-return valve. Co2 is fed into the carbonator from the bottom through a pressure regulating valve. Inside the carbonator is an ss shower, which sprays the water and ensures a good mix with Co2. Then there are a series of ss plates, which have holes in them. These effectively break up the water and facilitate further mixing. A gauge glass tube is provided to check the level of soda in the tank. The soda is now ready to be taken from a pipe at the bottom of the carbonator to the filling station. The contact parts of triplex pump are made of a stainless steel and a 1 hp iph/iiiph 1440 rpm motor drives it. The pump has a capacity of about 900 liters per hour. The pump consists of a dampener and an overflow regulator to ensure that the pump is not damaged when output pressure increases beyond its pumping capacity. The pressure regulating valve ensures that the Co2 is fed at a constant pressure into the carbonator. It has a safety release valve. The cast iron stand & base holds all the above three. It has holes to facilitate its foundation on the ground. Large size carbonator: The carbonator is basically a stainless steel pipe of dimensions 12” diameter and 5 feet height. It is fed water by a stainless steel triplex pump and Co2 through a pressure regulating valve. The whole assembly is mounted on a cast iron base. The description of each part is as follows: The carbonator pipe is made of ss 304 grade. It is clad with a temperature protection foam over which is an aluminum sheet. Water is fed from the pump into the top of the carbonator through a SS pipe set and a non-return valve. Co2 is fed into the carbonator from the bottom through a pressure regulating valve. Inside the carbonator is an SS shower, which sprays the water and ensures a good mix with Co2. Then there are a series of SS plates, which have holes in them. These effectively break up the water and facilitate further mixing. A gauge glass tube is provided to check the level of soda in the tank. The soda is now ready to be taken from a pipe at the bottom of the carbonator to the filling station. The contact parts of triplex pump are made of a stainless steel and a 1 Hp IPH/IIIPH1440 rpm motor drives it. The pump has a capacity of about 900 liters per hour. The pump consists of a dampener and an overflow regulator to ensure that the pump is not damaged when output pressure increases beyond its pumping capacity. The pressure regulating valve ensures that the Co2 is fed at a constant pressure into the carbonator. It has a safety release valve. The cast iron base holds all the above three. It has holes to facilitate its foundation on the ground.